|
Note: If your network contains assignment results, you may delete them either directly or within the procedure sequence, e.g. as the procedure which is directly followed by the new assignment calculation (Deleting PrT/PuT assignment results). |
1. Make sure the input attributes required for this procedure are available (Fundamentals: Settings for the PuT user model).
2. From the Calculate menu, choose General procedure settings.
The General procedure settings window opens.
3. Under PuT settings > Assignment, make the settings of your choice (Setting parameters for PuT assignments).
4. If required, edit the settings under PuT settings > Skims (Setting metadata for skim matrices and Setting parameters for PuT skim matrices).
|
Note: These settings are only regarded for simultaneous skim matrix calculation. |
5. Under Analysis time slots, make the desired settings (Adjusting the general procedure settings).
6. Under Volumes, make the settings of your choice (Saving volumes by demand segment or additively).
7. Confirm with OK.
8. From the Calculate menu, choose Procedure sequence.
The Procedure sequence window opens.
9. Add the PuT assignment procedure of the Assignments category to the desired position within the procedure sequence (Setting up and starting the procedure sequence).
10. In the row of the inserted procedure, click the button in the Reference object(s) column.
The Select Demand segments window opens.
11. In the Select mode selection list, click the desired entry.
12. In the Demand segments section, select the desired entries.
|
Tips: To select several individual entries hold down the Ctrl key while clicking each single entry. To select several consecutive entries hold down the Shift key while clicking the first and the last entry of the desired portion in the list. |
13. Confirm with OK.
The window closes. The selected demand segments are listed in the Reference object(s) column.
14. In the column Variant/file in the selection list, select the desired entry.
The selected entry is displayed in the column.
15. Select the operation added. Then in the Operations section, click the Edit button.
The Parameters for assignment procedure:... window opens.
16. Make the desired changes.
|
Note: The three procedures have different parameters.
|
17. Confirm with OK.
18. Execute the procedure (Executing procedures in the procedure sequence).
The assignment procedure is executed.
|
Note: You can show the results in a table or diagram, or use them for further evaluations (Displaying data graphically and in lists and Settings for interactive analyses). |
